Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-frontend" was enqueued with dependencies that are not registered: jquery-ui-position. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131

Owner Manuals

Peugeot Rifter 2018-2019 Owner's Manual Lighting and visibility Lighting control stalk

61Lighting and visibility4Lighting control stalkMain lightingAutomatic illumination of lamps/daytime running lampsSidelamps onlyDipped or main beam headlampsOperation of the selected lighting is confirmed by the illumination of the corresponding indicator lamp.In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal surface of the glass of the headlamps and rear lamps is normal; it disappears after the lamps have been on for a few minutes.Headlamp dippingPull the stalk to switch between dipped and main beam headlamps.In "AUTO" and sidelamps modes, the driver can switch on the main beam headlamps temporarily ("headlamp flash") by maintaining a pull on the stalk.Foglamps selection ringRear foglampsThey operate with the sidelamps on.►Rotate the ring forwards to switch them on and backwards to switch them off.When the lighting is switched off automatically ("AUTO" position), the foglamps and the dipped beam headlamps will remain on.With front and rear foglampsThey operate with the dipped beam headlamps on, in manual or auto mode.Turn and release the ring:►once forwards to switch on the front foglamps and then a second time for the rear foglamps.►once backwards to switch off the rear foglamps and then a second time for the front foglamps.If the lighting is switched off automatically ("AUTO" position) or the dipped beam headlamps are switched off manually, the foglamps and sidelamps will remain on.►Turn the ring backwards to switch the foglamps off; the sidelamps will then switch off.When the lighting is left onAn audible signal when a front door is opened warns the driver that the vehicle's exterior lighting is on, with the ignition off and in manual lighting mode.In this case, switching off the lighting stops the audible signal.
62Lighting and visibilityDaytime running lamps / SidelampsThe front lamps light up automatically when the engine starts.They provide the following functions:–Daytime running lamps (lighting control stalk in the "AUTO" position with adequate light level).–Sidelamps (lighting control stalk in the "AUTO" position with low light levels or "Sidelamps only” or "Dipped/main beam headlamps").The LEDs are brighter when operating as daytime running lamps.Parking lampsSide markers for the vehicle by illumination of the sidelamps on the traffic side only.►Depending on version, within one minute of switching off the ignition, operate the lighting control stalk up or down depending on the traffic side (for example: when parking on the left; The lighting goes off when you switch off the ignition, but you can always switch it on again using the lighting control stalk.Travelling abroad If using your vehicle in a country that drives on the other side of the road, the headlamps must be adjusted to avoid dazzling on-coming drivers.Contact a PEUGEOT dealer or a qualified workshop.In good or rainy weather, by both day and night, use of the front foglamps and the rear foglamps are prohibited. In these situations, the power of their beams may dazzle other drivers. They should only be used in fog or falling snow.In these weather conditions, it is your responsibility to switch on the foglamps and dipped headlamps manually as the sunshine sensor may detect sufficient light.Switch off the front and rear foglamps when they are no longer necessary.Never look too closely at the luminous beam of LED headlamps: risk of serious eye injury.Direction indicators►Left or right: lower or raise the lighting control stalk, beyond the point of resistance.Three flashes►Press briefly upwards or downwards, without going beyond the point of resistance; the direction indicators will flash 3 times.Automatic headlamp illuminationWhen a low level of ambient light is detected by a sunshine sensor, the number plate lamps,sidelamps and dipped beam headlamps are switched on automatically, without any action on the part of the driver. They can also come on if rain is detected, at the same time as the automatic rain sensitive wipers.As soon as the brightness returns to a sufficient level or after the windscreen wipers are switched off, the lamps are switched off automatically.►Turn the ring to the "AUTO" position. When the function is activated, a message is also displayed.►Turn the ring to another position. An onscreen message is displayed to confirm that the function has been deactivated.MalfunctionIn the event of a malfunction of the sunshine sensor, the lighting comes on and this warning lamp is displayed in the instrument panel, accompanied by an audible signal and/or a message.Contact a PEUGEOT dealer or a qualified workshop.In fog or snow, the sunshine sensor may detect sufficient light. In this case, the lighting will not come on automatically.Do not cover the sunshine sensor, located on the dashboard or at the top of the windscreen behind the rear view mirror (depending on equipment); the associated functions would no longer be controlled.
Scroll to Top

Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-pro-frontend" was enqueued with dependencies that are not registered: elementor-pro-webpack-runtime. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131