Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-frontend" was enqueued with dependencies that are not registered: jquery-ui-position. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131

Owner Manuals

Peugeot Rifter 2018-2019 Owner's Manual Ease of use and comfort Additional heating/ventilation system

57Ease of use and comfort3consumption in turn reduces fuel consumption.Rear screen demisting/defrosting can only operate with the engine is running.Rear heating and air conditioningIf your vehicle is so equipped, the temperature of the air distributed by the system is the same as the selection for the front.Air flow►Press one of the buttons 2 to increase/decrease the air flow.Additional heating/ventilation systemHeatingThis is an additional and separate system which heats the passenger compartment and improves defrosting performance.This indicator lamp is lit while the system is programmed or set in operation remotely via the remote control.It flashes during the whole duration of the heating and goes off at the end of the heating cycle or when stopped using the remote control.VentilationThis system allows ventilation of the passenger compartment with exterior air to improve the temperature experienced on entering the vehicle in summer.ProgrammingWith Bluetooth® audio system►Press the MENU button to access the main menu. ►Select "Pre-heat. / Pre-ventil.".►Select "Activation" and, if necessary, for programming, “Parameters".►Select "Heating" to heat the engine and passenger compartment or "Ventilation" to ventilate the passenger compartment.►Select:•the first clock to set/save the time at which the pre-heating temperature will be reached,•the second clock to set/save a second time at which the pre-heating temperature will be reached,Using these two clocks and depending on the season you can, for example, select one or the other start time.A message on the screen confirms your choice.
58Ease of use and comfortWith PEUGEOT Connect RadioPress Connect-App to display the main page.Then press "Programmable heating/ventilation".►Select the "Status" tab to activate/deactivate the system.►Select the "Other settings" tab to choose the "Heating" mode, to heat the engine and passenger compartment, or "Ventilation" to ventilate the passenger compartment.►Then set/save the time at which the preheating temperature will be reached for each selection.Press this button to save.With PEUGEOT Connect Nav►Press the "Applications" menu.►Press the "Vehicle Apps" tab.►Press "Temperature programming".►Press the "Status" tab to activate/deactivate the system.►Press the "Parameters" tab to select "Heating" mode to heat the engine and passenger compartment or "Ventilation" mode to ventilate the passenger compartment.►Then set/save the activation time for each selection.►Press "OK" to confirm.You must allow at least 60 minutes between programming operations.Long range remote control(Depending on version.)This enables you to switch the heating in the passenger compartment on or off from a distance.The remote control has a range of about 0.6 miles (1km) in open country.On►Pressing and holding this button starts the heating immediately (confirmed by the green indicator lamp coming on briefly).Off►Pressing and holding this button stops the heating immediately (confirmed by the red indicator lamp coming on briefly).The indicator lamp in the remote control flashes for about 2 seconds if the vehicle has not received the signal, in which caseyou should move to a different location and repeat the command.Changing the batteryThe indicator lamp in the remote control will change to orange if the battery charge is low.If the indicator lamp is not on, the battery is discharged.►Use a coin to unscrew the cap and replace the battery.The maximum heating period is about 45minutes depending on the climatic conditions.The ventilation is activated provided that the battery is sufficiently charged. The heating is activated provided that:
59Ease of use and comfort3–the battery charge and the fuel level are sufficient,–the engine has been started since the previous heating cycle,–60minutes have elapsed between two heating requests.The programmable heating is supplied by the vehicle fuel tank. Before use, make sure that you have sufficient fuel. If the fuel tank is on reserve, you are strongly recommended not to program the heating.The additional heating must always be switched off while refuelling to avoid any risk of fire or explosion.To avoid the risks of poisoning or asphyxia, the programmable heating must not be used, even for short periods, in a closed environment such as a garage or workshop which is not equipped with an exhaust gas extraction system.Do not park the vehicle on a flammable surface (dry grass, dead leaves, paper, etc.) - Risk of fire!Glazed surfaces such as the rear screen or windscreen can become very hot in places.Never put objects on these surfaces; never touch these surfaces - Risk of burns!Do not throw remote control batteries away, as they contain metals that are harmful to the environment. Take them to an approved disposal point.Courtesy lampAutomatic switching on/offThe front courtesy lamp comes on when the key is removed from the ignition switch.All courtesy lamps come on when the vehicle is unlocked, when one of the corresponding doors is opened and when locating the vehicle using the remote control. They fade to off after the ignition is switched on and when the vehicle is locked.Take care not to allow objects to come into contact with the courtesy lamp.Type 1Always lit, ignition on.Lights up when one of the front or rear doors is opened.Always off.Type 2
Scroll to Top

Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-pro-frontend" was enqueued with dependencies that are not registered: elementor-pro-webpack-runtime. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131