Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-frontend" was enqueued with dependencies that are not registered: jquery-ui-position. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131

Owner Manuals

Peugeot Partner 2008-2018 Owner's Manual Ready to Go Alarm

20AccessPartner-2-VU_en_Chap03_Pret-a-partir_ed02-2016Good practiceDo not make any modifications to the electronic immobiliser system.Operating the remote control, even when it is in your pocket, may result in involuntary unlocking of the doors.The simultaneous use of other high frequency equipment (mobile telephones, domestic alarms…), may interfere with the operation of the remote control temporarily.The remote control does not operate while the key is in the ignition, even if the ignition is off.ELECTRONICIMMOBILISERAll of the keys contain an electronic immobiliser device.This device locks the engine supply system. It is activated automatically when the key is removed from the ignition.After the ignition is switched on, a dialogue is established between the key and the electronic immobiliser system.The metal part of the key must be unfolded correctly for correct dialogue to take place.If you lose your keysVisit a PEUGEOT dealer with the vehicle's V5 registration certificate and your identification document.A PEUGEOT dealer will be able to retrieve the key code and the transponder code so that a replacement key can be ordered.Don't forgetWhen leaving the vehicle, check that the lighting is off and nothing of value is visible.As a safety precaution (with children on board), remove the key from the ignition when leaving the vehicle, even for a short time.When purchasing a second-hand vehicle, have the keys memorised by a PEUGEOT dealer, so as to be sure that the keys in your possession are the only ones that can be used to start the vehicle.ALARMIf fitted on your vehicle, this provides two types of protection:-exterior protection: it sounds if a front/rear door or the bonnet is opened.-interior protection: it sounds if the volume inside the passenger compartment changes (breaking of a window or a movement inside the vehicle).If your vehicle is fitted with a separation partition, the interior protection is not active in the load space.Locking the vehicle with complete alarmSetting the alarm-Switch off the ignition and get out of the vehicle.-Set the alarm within five minutes of getting out of the vehicle, by locking or deadlocking using the remote control. The red LED, located in the button, flashes once per second.
21AccessREADY TO GO3Partner-2-VU_en_Chap03_Pret-a-partir_ed02-2016FRONTDOORSFrom the insideUse the door opening control to unlock and open the door concerned.From the outsideUse the remote control to lock/unlock the vehicle.Insert the metal part of the key in the lock on the driver's side if the remote control does not work.Disarming-Unlock the vehicle with the remote control or switch on the ignition, the red LED goes off.Locking the vehicle with exterior protection onlyIf, while you are away from the vehicle, you wish to leave a window partially open or a pet inside the vehicle, you should choose exterior protection only.-Switch off the ignition.TriggeringThe siren sounds, the direction indicators flash for approximately 30seconds and the red LED flashes rapidly.-To switch it off, insert the key and switch on the ignition.When the alarm has been triggered ten times in succession (when triggered for the eleventh time) it is deactivated. Repeat the procedure for setting the alarm.Locking the vehicle without alarm-Insert the key in the lock on the driver's door and lock it.Do not set the alarm when washing your vehicle.Failure of the remote controlWhen the alarm is set but the remote control does not operate:-Unlock the doors with the key andopen the door. The alarm is triggered.-Switch on the ignition in the next ten seconds. The alarm is disarmed.Incorrect operationWhen the ignition is switched on, if the red LED remains on for ten seconds, there is a fault in the siren connection.Contact a PEUGEOT dealer to have the system checked.Automatic setting of the alarmDepending on the country in which the vehicle is sold, the alarm is set automatically approximately 2 minutes after the last door is closed.To prevent triggering of the alarm when a door is opened, you have to press the remote control unlocking button again.-In the next ten seconds, press the button until the red LED is on continuously.-Get out of the vehicle.-Within the next five minutes, set the alarm by locking or deadlocking using the remote control (the red LED flashes once a second).Do not make any modifications to the alarm system as this could cause faults.
Scroll to Top

Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-pro-frontend" was enqueued with dependencies that are not registered: elementor-pro-webpack-runtime. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131