Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-frontend" was enqueued with dependencies that are not registered: jquery-ui-position. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131

Owner Manuals

Peugeot Partner 1996-2008 Owner's Manual Accesses

15 Accesses READY TO SET OFF2 KEY This locks and unlocks the locks on the vehicle and starts the engine. ACCESSES Security of use REMOTE CONTROL Unlocking Unlocking the load space Central locking Press this button to lock the vehicle completely. The direction indicators fl ash once. If one of the doors is open (transportation of long loads) or is not closed correctly, the central locking will not work. Deadlocking A second press on the closed padlock on the remote control within fi ve seconds after locking changes the locking to deadlocking. This is confi rmed by fi xed lighting of the direction indicators for approximately two seconds. Deadlocking renders the exterior and interior door opening handles inoperative: do not leave anyone inside the vehicle when it is deadlocked. If deadlocking is activated from inside the vehicle using the remote control, it will change to normal locking when the vehicle is started. To unlock the load space only: Press this control to unlock the load space, the front doors alone remain locked. Press this control to lock the vehicle completely. Press this button to unlock all of the rear doors. Press this button once to unlock the front doors. Press this button again to unlock your vehicle completely. The direction indicators fl ash twice.
16 Accesses Good practice Take care not to allow the remote control to come into contact with grease, dust, rain or a damp environment. A heavy object attached to the key (keyring, ...) weighing on the shaft of the key in the switch, may cause a malfunction. REMOTE CONTROL Programming the remote control Following changing of the remote control battery or disconnection of the vehicle battery, the remote control may have to be reprogrammed. Wait at least one minute before using the remote control. Insert the key in the ignition switch with the buttons (padlocks) of the remote control facing you. Switch on the ignition. Press the locking padlock for at least fi ve seconds within the next ten seconds. Switch off the ignition. Wait at least one minute before using the remote control. The remote control is now working again. Use only identical batteries or batteries of an equivalent type to those recommended by PEUGEOT dealers. Do not discard the remote control batteries, they contain metals which are harmful to the environment. Deposit them at a PEUGEOT dealership, or at any other approved collection point. Folding/unfolding the key Changing the battery Battery ref.: CR1620/3 volts. The information "battery fl at" is given by an audible signal, accompanied by a message on the display. To replace the battery, unclip the casing using a coin at the ring. If the remote control does not work after the battery has been changed, re-programme the remote control. There is a risk of damage if the replacement battery does not conform. Press this button to release the key from its housing. To fold the key, press this chromed button then fold the key into the housing. If you do not press the button, the mechanism may be damaged.
17 Accesses READY TO SET OFF2When purchasing a second-hand vehicle: - have the keys memorised by a PEUGEOT dealer to ensure that the keys in your possession are the only ones which can start the vehicle. Good practice Do not make any modifi cations to the electronic immobiliser system. Operating the remote control, even when it is in your pocket, may result in involuntary unlocking of the doors. The simultaneous use of other high frequency equipment (mobile telephones, domestic alarms…), may interfere with the operation of the remote control temporarily. ELECTRONIC IMMOBILISER All of the keys contain an electronic immobiliser device. This device locks the engine supply system. It is activated automatically when the key is removed from the ignition. After the ignition is switched on, a dialogue is established between the key and the electronic immobiliser system. The metal part of the key must be unfolded correctly for correct dialogue to take place. If you lose your keys Visit a PEUGEOT dealer with the vehicle’s V5 registration document and your identifi cation document. A PEUGEOT dealer will be able to retrieve the key code and the transponder code so that a replacement key can be ordered. The remote control does not operate while the key is in the ignition, even if the ignition is off. As a safety precaution (with children on board), remove the key from the ignition when leaving the vehicle, even for a short time. ALARM If fi tted on your vehicle, this provides two types of protection: - exterior protection: it sounds if a front/rear door or the bonnet is opened. - interior protection: it sounds if the volume inside the passenger compartment changes (breaking of a window or a movement inside the vehicle). If your vehicle is fi tted with a separation partition, the interior protection is not active in the load space. Locking the vehicle with complete alarm Setting the alarm - Switch off the ignition and get out of the vehicle. - Set the alarm within fi ve minutes of getting out of the vehicle, by locking or deadlocking using the remote control. The red diode, located on the button, fl ashes once per second.
18 Accesses FRONT DOORS From the inside Use the door opening control to unlock and open the door concerned. From the outside Use the remote control to lock/unlock the vehicle. Insert the metal part of the key in the lock on the driver’s side if the remote control does not work. Triggering The siren sounds, the direction indicators fl ash for approximately 30 seconds and the red diode fl ashes rapidly. - To switch it off, insert the key and switch on the ignition. When the alarm has been triggered ten times in succession (when triggered for the eleventh time) it is deactivated. Repeat the rules for setting the alarm. Locking the vehicle without alarm - Insert the key in the lock on the driver’s door and lock it. Do not set the alarm when washing your vehicle. Failure of the remote control When the alarm is set but the remote control does not operate: - Unlock the doors with the key and open the door. The alarm is triggered. - Switch on the ignition in the next ten seconds. The alarm is disarmed. Incorrect operation When the ignition is switched on, if the red diode remains on for ten seconds, there is a fault in the siren connection. Contact a PEUGEOT dealer to have the system checked. Automatic setting of the alarm Depending on the country in which the vehicle is sold, the alarm is set automatically approximately 2 minutes after the last door is closed. To prevent triggering of the alarm when a door is opened, it is imperative to press the remote control unlocking button again. Do not make any modifi cations to the alarm system as this could cause faults. Locking the vehicle with exterior protection only If, while you are away from the vehicle, you wish to leave a window partially open or a pet inside the vehicle, you should choose exterior protection only. - Switch off the ignition. - In the next ten seconds, press the button until the red diode is on continuously. - Get out of the vehicle. - Within the next fi ve minutes, set the alarm by locking or deadlocking using the remote control (the red diode fl ashes once a second). Disarming - Unlock the vehicle with the remote control or switch on the ignition, the red diode goes out.
19 Accesses READY TO SET OFF2 From the inside Unlock and open the side door using this handle, guiding the rearward sliding to the point of resistance. Pass this point to hold the door open. Good practice Take care not to block the guide space on the fl oor to allow the door to slide correctly. If your vehicle is parked on a slope, guide the sliding of the side door. In fact, the door could open or close more rapidly due to the slope of the ground and could cause injury. For safety and operation reasons, do not drive with the sliding side door open. From the outside Pull the handle towards you then towards the rear and open the side door, guiding the rearward sliding to beyond the point of resistance to hold it open.
Accesses Practice It is possible to drive with the right-hand door open to make the transportation of long loads easier. The left-hand door is kept closed by the distinctive "yellow" lock, positioned at the base of the door. This closed door must not be used as a load retainer. Driving with the right-hand door open is a special dispensation. Comply with the usual safety indications to attract the attention of other drivers. HINGED REAR DOORS From outside Pull the lever to open the right-hand door. To close, start with the right-hand door then close the left-hand door. To open, pull the handle towards you. The hinged rear doors are asymmetrical (2/3 - 1/3), with the smaller door on the right. They are fi tted with a central lock. With the roof rear fl ap, the rear bumper has been strengthened to serve as a footrest on accessing the vehicle.
21 Accesses READY TO SET OFF2 From inside Pull the handle towards you to open the left-hand door. Opening to approximately 180° A check strap system permits extension of the opening from approximately 90° to approximately 180°. Pull the yellow control when the door is open. The check strap will re-attach automatically on closing.
22 Accesses REAR ROOF FLAP This rear roof fl ap is only compatible with the hinged doors. To open the rear roof fl ap: - raise the black paddle of the toggle, - relieve the toggle by pressing the rear roof fl ap (downwards) then release the hook, - lift the rear roof fl ap, - pass the point of resistance to secure the rear roof fl ap using the support struts. Support bar A support bar is provided for transporting long loads, after opening the rear roof fl ap. Fold back the support bar by lifting the lever. Support it to the door pillar. Support the long loads to be transported, lift them and reposition the support bar with one hand. Ensure that it is secured correctly by pressing the handle downwards past the point of resistance and secure the loads fi rmly. The rear bumper has been strengthened to serve as a footrest on entering the vehicle. Never drive without the support bar in place. The rear doors only lock when the support bar is installed. When the rear roof fl ap is open, take care when driving where height is restricted. Never rest loads directly on the rear doors. Comply with the usual indications, to attract the attention of other drivers. The side supports can be used as hooking points. - lower the black paddle to secure the rear roof fl ap. Securing the rear roof fl ap places it on the seal correctly and guarantees sealing without noise. To close the rear roof fl ap: - check that the support bar is secured correctly, - lower the rear roof fl ap, - while pressing the rear roof fl ap (downwards), take hold of the two loops of the spring then place the hook in its housing,
23 Accesses READY TO SET OFF2 TAILGATE From outside Locking/unlocking is by means of the remote control. To open, press the control below the trim then raise the tailgate. A pull strap is available to close the tailgate in the high position. Guide the closing of the tailgate to the balance point of its travel then apply a fi nal press on the tailgate to close it fully. From inside Emergency control In the event of a central unlocking operating fault, this permits unlocking of the tailgate from the inside. Insert a small screwdriver in the opening, between the door and the fl oor. To unlock the lock, move the catch to the left then push the tailgate. Tailgate screen The opening rear screen allows you to access the rear of the vehicle directly, without having to open the tailgate. Opening After unlocking the vehicle using the remote control or the key, press the control and raise the rear screen to open it. Closing Close the rear screen by pressing the centre of the glass until it is fully closed. The tailgate and tailgate screen cannot both be open at the same time, to prevent damage to the glass and the screen itself.
Accesses The control diode: - fl ashes when the doors are locked with the vehicle stationary and the engine off, - comes on when the doors are locked and from the time the ignition is switched on. CENTRAL LOCKING Cab and load space Load space Locking while driving When the vehicle moves off, as soon as you reach approximately 6 mph (10 km/h), the system locks the doors. A noise characteristic of central locking is heard. The diode on the control on the fascia central control panel comes on. During the journey, opening a door results in complete unlocking of the vehicle. In the event of a serious impact, the doors are unlocked automatically to permit access by the emergency services. Protection against attack An initial press permits central locking of the front and rear doors, when they are closed. A second press permits central unlocking of the vehicle. The control is inactive when the vehicle has been locked using the remote control or the key from the outside. Activating/deactivating the function With the ignition on, press and hold this button to activate or deactivate the function. Door open warning light If this warning light comes on, check that all of your vehicle’s doors are closed correctly. Press to lock/unlock the rear doors without changing the locking status of the cab. The doors can still be opened from the inside.
Scroll to Top

Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-pro-frontend" was enqueued with dependencies that are not registered: elementor-pro-webpack-runtime. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131