Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-frontend" was enqueued with dependencies that are not registered: jquery-ui-position. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131

Owner Manuals

Peugeot 3008 2016-2023 Driving Distraction detection

153Driving6The brake pedal may feel hard and vibrate slightly while the function is operating.If the vehicle comes to a complete stop, automatic braking is maintained for 1 to 2 seconds.MalfunctionThis warning lamp lights up on the instrument panel with the message "Sensor blind" in certain cases.Version with camera only: the system is deactivated.Version with camera and radar: the system may continue to operate in a degraded mode.This may be caused by a reduced visibility (e.g.rain, fog, snow, blinding by low sun) or by a real sensor blockage. In this case, stop the vehicle and verify if the front camera or the front radar is covered by dirt, snow, ice or anything preventing the sensing.In the event of a malfunction, this warning lamp lights up on the instrument panel, accompanied by the display of a message and an audible signal.Have it checked by a PEUGEOT dealer or a qualified workshop.These warning lamps light up on the instrument panel and/or in the warning lamp display for seat belts and front passenger airbag to indicate that the driver's and/or front passenger's seat belt is not fastened (depending on version). The automatic braking system is deactivated until the seat belts are fastened.Distraction detectionFor more information, refer to the General recommendations on the use of driving and manoeuvring aids.Depending on version, the function consists of either the "Driver Attention Warning" system alone or combined with the "Driver Attention Warning by Camera" system.These systems are in no way designed to keep the driver awake or to prevent the driver from falling asleep at the wheel. It is the driver’s responsibility to stop if feeling tired.Take a break if you are feeling tired or at least every 2 hours.Activation/DeactivationThis function is set via the touch screen Driving/Vehicle menu.The state of the system is memorised when the ignition is switched off.Driver Attention WarningThe system triggers an alert when it detects that the driver has not taken a break after two hours of driving at a speed above 43 mph (70km/h).This alert is issued via the display of a message encouraging the driver to take a break, accompanied by an audible signal.If the driver does not follow this advice, the alert is repeated hourly until the vehicle is stopped.The system resets itself if one of the following conditions is met:–With the engine running, the vehicle has been stationary for more than 15 minutes.–The ignition has been switched off for a few minutes.–The driver's seat belt is unfastened and their door is opened.As soon as the speed of the vehicle drops below 43mph (70km/h), the system goes into standby.Driving time starts being counted again once the speed reaches above 43mph (70km/h).Driver Attention Warning by CameraDepending on version, the Driver Attention Warning system may be combined with the Driver Attention Warning by Camera system.
154DrivingThe system assesses the driver's level of alertness, fatigue and distraction by identifying trajectory changes in relation to the lane markings.To do this, the system uses a camera, placed on the upper part of the windscreen.This system is particularly suited to fast roads (speed higher than 43 mph (70km/h)).At a first alert level, the driver is warned by the message "Be vigilant!", accompanied by an audible signal.After three first-level alerts, the system triggers a further alert with the message "Dangerous driving: take a break", accompanied by a more pronounced audible signal.In certain driving conditions (poor road surface or strong winds), the system may give alerts independent of the driver's level of vigilance.The following situations may interfere with the operation of the system or prevent it from working:–lane markings absent, worn, hidden (snow, mud) or multiple (roadworks);–close to the vehicle ahead (lane markings not detected);–roads that are narrow, winding, etc.Blind spot monitoringFor more information, refer to the General recommendations on the use of driving and manoeuvring aids.This system warns the driver of a potential danger posed by the presence of another vehicle (car, lorry, motorcycle) in the vehicle's blind spots (areas hidden from the driver's field of vision) using sensors located on the sides of the bumpers.A warning lamp appears in the door mirror on the side in question:–fixed, immediately, when being overtaken.–flashing, after a delay of about one second, when overtaking a vehicle slowly, and when the direction indicator is used.Activation/DeactivationIt is set via the Driving/Vehicle touch screen menu.When the function is activated, this indicator lamp comes on in the instrument panel.When starting the vehicle, thewarninglamp comes on in each mirror to indicate that the system is activated.The status of the system is memorised when the ignition is switched off.The system is automatically deactivated when towing with a towing device approved by PEUGEOT.Operating conditions–All vehicles are moving in the same direction and in adjacent lanes.
Scroll to Top

Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-pro-frontend" was enqueued with dependencies that are not registered: elementor-pro-webpack-runtime. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131