Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-frontend" was enqueued with dependencies that are not registered: jquery-ui-position. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131

Owner Manuals

Peugeot 208 2020-2025 Practical information Energy economy mode

152Practical informationIf a telephone call is in progress at the time, it will be maintained for around 10 minutes via the audio system’s hands-free system.Exiting the modeThese functions are automatically reactivated the next time the vehicle is used.To restore the use of these functions immediately, start the engine and let it run:–For less than 10 minutes, to use the equipment for approximately 5 minutes.–For more than 10 minutes, to use the equipment for approximately 30 minutes.Let the engine run for the specified duration to ensure that the battery charge is sufficient.To recharge the battery, avoid repeatedly or continuously restarting the engine.A flat battery prevents the engine from starting.For more information on the 12V battery, refer to the corresponding section.Load reduction modeThis system manages the use of certain functions according to the level of charge remaining in the battery.When the vehicle is being driven, the load reduction function temporarily deactivates certain ►Use wire cutters, taking care not to cut the tabs that are to be retained.The cuttinginstructions are printed on each inner face of the 2 upper very cold climate screens.►Place one of the upper screens against the corresponding side of the upper bumper grille.►First insert the upper mounting tabs into the bumper.►Tilt the screen downwards until the lower mounting tabs are properly seated in the bumper (press on each tab to ensure it clicks into place).►Check that the unit is held firmly in place by pressing around the edges.Repeat the same steps for the other upper screen, then for the side screen in the grille below the number plate.Lower very cold climate screen►Place the lower screen against the lower bumper grille.►Insert the mounting tabs into the bumper until they are all properly seated.►Check that the unit is held firmly in place by pressing around the edges.RemovingFor the lower and side very cold climate screen►Insert a screwdriver into the slots located on the top of the lower screen and side screen to detach them from the grille.►Gently tilt the upper screen and side screen downwards.►Pull the unit towards you and support it as it becomes unclipped.For the upper very cold climate screens►Press the lower mounting lugs to release them from the grille.►Gently tilt the upper screen upwards.►Pull the unit towards you and support it as it becomes unclipped.Energy economy modeThis system manages the duration of use of certain functions, in order to conserve a sufficient level of charge in the battery with the ignition off.After switching off the engine and for a maximum cumulative period of around 30 minutes, you can continue to use functions such as the audio and telematics system, dipped beam headlamps or courtesy lamps.Selecting the modeA confirmation message is displayed when energy economy mode is entered, and the active functions are placed on standby.
153Practical information7If a telephone call is in progress at the time, it will be maintained for around 10 minutes via the audio system’s hands-free system.Exiting the modeThese functions are automatically reactivated the next time the vehicle is used.To restore the use of these functions immediately, start the engine and let it run:–For less than 10 minutes, to use the equipment for approximately 5 minutes.–For more than 10 minutes, to use the equipment for approximately 30 minutes.Let the engine run for the specified duration to ensure that the battery charge is sufficient.To recharge the battery, avoid repeatedly or continuously restarting the engine.A flat battery prevents the engine from starting.For more information on the 12V battery, refer to the corresponding section.Load reduction modeThis system manages the use of certain functions according to the level of charge remaining in the battery.When the vehicle is being driven, the load reduction function temporarily deactivates certain functions, such as the air conditioning and the heated rear screen.The deactivated functions are reactivated automatically as soon as conditions permit.BonnetStop & StartBefore doing anything under the bonnet, you must switch off the ignition to avoid any risk of the engine restarting automatically.Take care with objects or clothing that could be caught in the blades of the cooling fan or in certain moving components - risk of strangulation and serious injury!Electric motorTake care with objects or clothing that could be caught in the blades of the cooling fan or in certain moving components - risk of strangulation and serious injury!Before carrying out any work under the bonnet, you must switch off the ignition, check that the READY indicator lamp is off on the instrument panel and disconnect the charging nozzle if it is plugged in.The location of the interior bonnet release lever prevents the bonnet being opened when the left-hand front door is closed.When the engine is hot, handle the exterior safety catch and the bonnet stay with care (risk of burns), using the protected area.When the bonnet is open, take care not to damage the safety catch.Do not open the bonnet under very windy conditions.Cooling of the engine when stoppedThe engine cooling fan may start after the engine has been switched off.Take care with objects or clothing that could be caught in the blades of the fan!
Scroll to Top

Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-pro-frontend" was enqueued with dependencies that are not registered: elementor-pro-webpack-runtime. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131