Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-frontend" was enqueued with dependencies that are not registered: jquery-ui-position. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131

Owner Manuals

Peugeot 207 2009-2011 Practical Information Battery

9PRACTICAL INFORMATION153BATTERY Procedure for charging your battery when it is fl at or for starting the engine using another battery. Access to the battery Starting using another battery � Connect the red cable to the posi-tive terminal (+) of the fl at battery A , then to the positive terminal (+) of the slave battery B . � Connect one end of the green or black cable to the negative terminal (-) of the slave battery B . � Connect the other end of the green or black cable to the vehicle's offset earth point. � Start the support vehicle. � Operate the starter of the broken down vehicle and let the engine run. � Wait until the engine returns to idle and disconnect the cables. The battery is located under the bonnet. To gain access to it: � open the bonnet using the interior re-lease lever, then the exterior safety catch, � secure the bonnet stay, � lift the plastic cover on the (+) terminal.
9!iiPRACTICAL INFORMATION154 Do not charge the batteries with-out disconnecting the terminals fi rst. Do not disconnect the terminals while the engine is running. The batteries contain harmful sub-stances such as sulphuric acid and lead. They must be disposed of in accordance with regulations and must not, in any circumstanc-es, be discarded with household waste. Take used remote control batteries and vehicle batteries to a special col-lection point. Charging the battery using a battery charger �Disconnect the battery from the vehicle. � Follow the instructions for use pro-vided by the manufacturer of the charger. � Reconnect starting with the negative terminal (-). � Check that the terminals and connec-tors are clean. If they are covered with sulphate (whitish or greenish deposit), remove them and clean them. It is advisable to disconnect the battery if the vehicle is to be left unused for more than one month. Before disconnecting the battery Wait 2 minutes after switching off the ignition before disconnecting the battery. Close the windows and the doors before disconnecting the battery. Following reconnection of the battery Following reconnection of the bat-tery, switch on the ignition and wait 1 minute before starting to permit initialisation of the electronic sys-tems. However, if slight diffi cul-ties are encountered following this operation, contact a PEUGEOT dealer or a qualifi ed workshop. Referring to the corresponding section, you must yourself reini-tialise: - the remote control key, - the one-touch electric windows, - the GPS satellite navigation system. Disconnecting the cables Reconnecting the cables � Position the open clip 1 of the cable on the positive terminal (+) of the battery. � Press vertically on the clip 1 to position it correctly against the battery. � Lock the clip by spreading the position-ing lug and then lowering the tab 2 . � Raise the locking tab fully. Do not force the tab as locking will not be possible if the clip is not po-sitioned correctly; start the proce-dure again.
Scroll to Top

Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-pro-frontend" was enqueued with dependencies that are not registered: elementor-pro-webpack-runtime. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131