Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-frontend" was enqueued with dependencies that are not registered: jquery-ui-position. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131

Owner Manuals

Peugeot 206 2009-2014 Owner's Manual Access Changing the remote control battery

i4545 Steering lock Before starting, unlock the steering, if necessary, by turning the steering wheel slightly while turning the key. It is advisable to press the clutch pedal whle operating the starter to facilitate the starting of the engine. ELECTRONIC ENGINE IMMOBILISER This locks the engine management sys-tem as soon as the ignition has been switched off and therefore prevents starting of the vehicle by anyone who does not have the key. The ignition key has an electronic chip which has a special code. When the ig-nition is switched on, the code must be recognised for starting to be possible. If the system does not function cor-rectly, the central locking button in-dicator lamp, situated on the centre console, fl ashes rapidly when the igni-tion is switched on (2nd notch). In this case your vehicle will not start. Contact a PEUGEOT dealer as soon as possible. Key in ignition If the key is left in the ignition, this is indicated by an audible signal when the driver's door is opened. Locating your vehicle To locate your vehicle, if you have locked it, in a car park: press button A , the courtesy lamps come on and the direction indicators fl ash for a few seconds. Changing the remote control battery Battery ref.: CR2016/3 volts. If the remote control battery is fl at, you are warned by a message on display B. To replace the battery, remove the screw then unclip the casing using a coin at the ring. If the remote control does not work after the battery has been changed, repro-gramme the remote control. Reinitialising the remote control Switch off the ignition. Switch the ignition on again. Press button A immediately for a few seconds. Switch off the ignition and remove the remote control key from the igni-tion lock. The remote control is now working again.
!46 Keys Make a careful note of the number of each key. This number is coded on the label attached to the key. Remote control The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the vehicle, without you being aware of it. Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it from working and the remote control would have to be reprogrammed. The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except for reinitialisation. Do not throw the remote control bat-teries away, they contain metals which are harmful to the environment. Take them to an approved collection point. Locking the vehicle Driving with the doors locked may make access to the passenger compartment by the emergency services more diffi cult in an emergency. As a safety precaution (with children on board), remove the key from the ignition when you leave the vehicle, even for a short time. Anti-theft protection Do not make any modifi cations to the electronic engine immobiliser system, this could cause malfunctions. When purchasing a second-hand vehicle Have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle. Lost keys Visit a PEUGEOT dealer with the vehicle's V5 registration certifi cate and your personal identifi cation documents. The PEUGEOT network will be able to retrieve the key code and the transponder code to order a replacement key.
i!44KEYS Central locking and unlocking From the front doors, the keys allow you to lock and unlock the doors and boot. If one of the doors is open, the central locking does not work. If the boot is open, the central locking works. Remote control This carries out the same functions as the key, from a distance. Locking Press button A to lock the vehicle. This is confi rmed by fi xed lighting of the direction indicators for approximately two seconds. Unlocking Press button B to unlock the vehicle. This is confi rmed by rapid fl ashing of the direction indicators. Starting the vehicle There are four possible positions of the key in the ignition switch: 1.STOP position: the ignition is off. 2.1 st notch, Accessories position: the ignition is off but the accessories can operate. 3.2nd notch, On position: the ignition is on. 4.Starting position: the starter is operated. Avoid pressing the buttons of your remote control out of range of your vehicle as this could stop it from working. The remote control would then have to be reinitialised (refer to the corresponding section). A heavy object (key ring, etc.), at-tached to the key and weighing down on its shaft in the switch, may cause a malfunction.
i4545 Steering lock Before starting, unlock the steering, if necessary, by turning the steering wheel slightly while turning the key. It is advisable to press the clutch pedal whle operating the starter to facilitate the starting of the engine. ELECTRONIC ENGINE IMMOBILISER This locks the engine management sys-tem as soon as the ignition has been switched off and therefore prevents starting of the vehicle by anyone who does not have the key. The ignition key has an electronic chip which has a special code. When the ig-nition is switched on, the code must be recognised for starting to be possible. If the system does not function cor-rectly, the central locking button in-dicator lamp, situated on the centre console, fl ashes rapidly when the igni-tion is switched on (2nd notch). In this case your vehicle will not start. Contact a PEUGEOT dealer as soon as possible. Key in ignition If the key is left in the ignition, this is indicated by an audible signal when the driver's door is opened. Locating your vehicle To locate your vehicle, if you have locked it, in a car park: press button A , the courtesy lamps come on and the direction indicators fl ash for a few seconds. Changing the remote control battery Battery ref.: CR2016/3 volts. If the remote control battery is fl at, you are warned by a message on display B. To replace the battery, remove the screw then unclip the casing using a coin at the ring. If the remote control does not work after the battery has been changed, repro-gramme the remote control. Reinitialising the remote control Switch off the ignition. Switch the ignition on again. Press button A immediately for a few seconds. Switch off the ignition and remove the remote control key from the igni-tion lock. The remote control is now working again.
Scroll to Top

Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-pro-frontend" was enqueued with dependencies that are not registered: elementor-pro-webpack-runtime. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131