Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-frontend" was enqueued with dependencies that are not registered: jquery-ui-position. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131

Owner Manuals

Peugeot 2008 2019-2025 Owner's Manual Driving Starting/Switching off the engine with Keyless Entry and Start

94DrivingIf the engine does not start straight away, switch off the ignition. Wait a few seconds before operating the starter motor again. If the engine does not start after a few attempts, do not keep trying - risk of damaging the starter motor and the engine!Contact a PEUGEOT dealer or a qualified workshop.Switching off the engine►Immobilise the vehicle.►With the engine at idle, turn the key to position 1.►Remove the key from the ignition switch.►To lock the steering column, turn the steering wheel until it locks.To facilitate unlocking of the steering column, it is recommended that the wheels be returned to the straight ahead position before switching off the engine.Never switch off the ignition before the complete immobilisation of the vehicle. With the engine off, the braking and steering assistance systems are also cut off - risk of loss of control of the vehicle!Check that the parking brake is correctly applied, particularly on sloping ground.When leaving the vehicle, keep the key in your possession and lock the vehicle.Energy economy modeAfter the engine has stopped (position 1. Stop), for a maximum combined duration of 30 minutes, you can still use functions such as the audio and telematics system, courtesy lamps or dipped beam headlamps.For more information on Energy economy mode, refer to the corresponding section.Key left inWhen the driver's door is opened, a message is displayed, accompanied by an audible signal, if the key has been left in the ignition switch in position 1.If the key has been left in the ignition switch in position 2, the ignition will be switched off automatically after one hour.To switch the ignition back on, turn the key to position 1, then back to position 2.Starting/Switching off the engine with Keyless Entry and StartThe electronic key must be present in the passenger compartment.The electronic key is also detected in the boot.If the electronic key is not detected, a message is displayed.Move the electronic key so that the engine can be started or switched off.If there is still a problem, refer to the "Key not detected - Back-up starting or Back-up switch-off" section.Starting►With a manual gearbox, place the gear lever in neutral and fully depress the clutch pedal.►With an automatic gearbox, select modePorN and depress the brake pedal.►Press the "START/STOP" button while maintaining pressure on the pedal until the engine starts.Diesel enginesIn negative temperatures and/or when the engine is cold, starting takes place only after the preheating warning lamp goes out.If this warning lamp comes on after pressing the "START/STOP" button:
95Driving6►Keep the pedal fully depressed and do not press the "START/STOP" button again until the engine is running.In all circumstances, if one of the starting conditions is not met, a message is displayed.In some circumstances, a message indicates that it is necessary to turn the steering wheel while pressing the "START/STOP" button to assist unlocking of the steering column.Petrol enginesWith Petrol engines, after a cold start, pre-heating the catalytic converter can cause noticeable engine vibrations, for anything up to 2minutes (accelerated idle speed).If the engine stalls, release the clutch pedal and fully depress it again, the engine will restart automatically.Switching off►Immobilise the vehicle using the parking brake.►With a manual gearbox, ideally put the gear lever into neutral.►With an automatic gearbox, ideally select modeP orN.►Press the "START/STOP" button.In some circumstances, it is necessary to turn the steering wheel to lock the steering column.If the vehicle is not immobilised, the engine will not stop.With the engine off, the braking and steering assistance systems are also cut off - risk of loss of control of the vehicle!Never leave your vehicle with the electronic key still inside.Starting/Switching off the electric motorStartingThe drive selector must be in mode P.►Fully depress the brake pedal and briefly press the "START/STOP" button.►Keep your foot on the brake pedal until the READY indicator lamp comes on and an audible signal is emitted, indicating that the vehicle is ready to drive.►With your foot on the brake, press the "Unlock" button and select modeD/B or R.►Release the brake pedal, then accelerate.On starting, the instrument panel lights up and the power indicator needle or cursor moves to the "neutral" position. The steering column automatically unlocks (you may hear a sound and feel the steering wheel move).Switching off►Press the "START/STOP" button.Before exiting the vehicle, check that:–The drive selector is in mode P.–The READY indicator lamp is off.If the driver's door is opened while the required conditions for stopping are not satisfied, an audible signal is emitted, accompanied by the display of a warning message.Switching on the ignition without starting the engineWith the electronic key in the passenger compartment, pressing the "START/STOP" button, without depressing any of the pedals, allows the ignition to be switched on without starting the engine.►Press this button again to switch off the ignition and allow the vehicle to be locked.Key not detectedBack-up startingA back-up reader is fitted to the steering column, to enable the engine to be started if the system
Scroll to Top

Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-pro-frontend" was enqueued with dependencies that are not registered: elementor-pro-webpack-runtime. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131