Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-frontend" was enqueued with dependencies that are not registered: jquery-ui-position. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131

Owner Manuals

Peugeot 2008 2019-2025 Owner's Manual Access Doors

37Access2Risk of explosion or leaking of inflammable liquid or gas!Do not use in/store in/place in an environment where the temperature is extremely high or where the pressure is extremely low due to very high altitude.Do not try to burn, crush or cut a used battery.Reinitialising the remote controlFollowing replacement of the battery or in the event of a fault, it may be necessary to reinitialise the remote control.Without Keyless Entry and Start►Switch the ignition off.►Turn the key to position 2 (Ignition on).►Immediately press the closed padlock button for a few seconds.►Switch off the ignition and remove the key from the ignition switch.The remote control is now fully operational again.With Keyless Entry and Start►Insert the mechanical key (incorporated into the remote control) into the lock to open the vehicle.►Place the electronic key against the back-up reader on the steering column and hold it there until the ignition is switched on.►With a manual gearbox, place the gear lever in neutral then fully depress the clutch pedal.►With an automatic gearbox or drive selector, while in modeP, depress the brake pedal.►Switch on the ignition by pressing the "START/STOP" button.If the fault persists after reinitialisation, contact a PEUGEOT dealer or a qualified workshop without delay.DoorsOpeningFrom outside►After unlocking the vehicle or with the "Keyless Entry and Start" system electronic key in the recognition zone, pull the door handle.From inside►Pull the interior opening control of a door; this unlocks the vehicle completely.With selective unlocking activated:–Opening the driver's door unlocks the driver's door only (if the vehicle has not already been completely unlocked).–Opening one of the passenger doors unlocks the rest of the vehicle.ClosingIf a door is not properly closed, this warning lamp comes on accompanied by a message if the engine is running, and an audible signal when the vehicle is travelling at more than 6mph (10km/h).
38AccessBootOpening►After unlocking the vehicle or just the boot (depending on version), press the opening control and then lift the tailgate.Closing►Lower the tailgate using one of the interior grab handles.In the event of a malfunction or if you experience difficulty opening or closing the tailgate, have it checked by a PEUGEOT dealer or a qualified workshop without delay, to avoid the issue deteriorating and prevent any risk of the tailgate dropping, potentially causing serious injury.Back-up releaseTo manually unlock the boot in the event of a battery or central locking failure.Unlocking►Fold the rear seats to gain access to the lock from inside the boot.►Insert a small screwdriver into hole A of the lock to unlock the boot.►Move the latch to the left.Locking after closingIf the fault persists after closing again, the boot will remain locked.In the event of a fault with the central locking system, it is essential to disconnect the battery to lock the boot and so ensure complete locking of the vehicle.Alarm(Depending on version)System which protects and provides a deterrent against theft and break-ins.Exterior perimeter monitoringThe system checks for opening of the vehicle.The alarm is triggered if anyone tries to open a door, the boot or the bonnet, for example.Interior volumetric monitoringThe system checks for any variation in volume in the passenger compartment.The alarm is triggered if anyone breaks a window, enters the passenger compartment or moves inside the vehicle.Anti-tilt monitoringThe system checks for any change in the attitude of the vehicle.The alarm goes off if the vehicle is lifted or moved.When the vehicle is parked, the alarm will not be triggered if the vehicle is knocked.Self-protection functionThe system checks whether any of its components are out of service.The alarm is triggered if the battery, the central control or the siren wiring is put out of service or damaged.Work on the alarm systemConsult a PEUGEOT dealer or a qualified workshop.
Scroll to Top

Notice: Function WP_Scripts::add was called incorrectly. The script with the handle "elementor-pro-frontend" was enqueued with dependencies that are not registered: elementor-pro-webpack-runtime. Please see Debugging in WordPress for more information. (This message was added in version 6.9.1.) in /home/u918277800/domains/ownersmanual.store/public_html/wp-includes/functions.php on line 6131